SARS-CoV-2 Nucleocapsid Antigen Rapid Test (Uncut pad)

Catalog# BRT1002

Size: 300 mm (length)×60 mm (width), enough for 75-100 strips.

Lot # Check on the product label

Introduction

This product was used for detecting the SARS-CoV-2 Nucleocapsid proteins/antigens in Lateral Flow (rapid test) application.

Kit Components

Antibodies Information

• Conjugate pad: Colloidal gold conjugated #BDA1078 (SARS-CoV-2 Nucleocapsid antibody with Clone # 6B3 ) & Colloidal gold #BSA1046 (Chicken IgY).
• T line: #BDA1077 (SARS-CoV-2 Nucleocapsid antibody with Clone # 8B2).
• C line: #BSA1047 (Rabbit anti-chicken IgY).

Protocol

1. Open the aluminum foil bag to get the uncut pad, cut it into strips by a clean knife or scissors. It is recommended to cut each strip with 3-4 mm x 60 mm.

2. Assemble the strips into the test card for assay or analyze with the strips directly.

3. Add 60 µl (If cut the strip with 3 mm x 60 mm) or 80 µl (If cut the strip with 4 mm x 60 mm) of properly diluted samples or BRP1131 (SARS-CoV-2 Nucleocapsid full length protein) or suitable positive control to the sample hole.

(Note: A. Please dilute the samples with the provided Sample diluent buffer.

B. For BRP1131, it is suggested to dilute at 1:1000 with the Sample diluent buffer at first then upload, if the positive signal is weak, then, optimize the dilution.)

4. Read the results at 15 min. Strong positive results may be observed in 2-3 minutes. Weak positive results may take longer time, up to 5 minutes to develop. Results read after 18 min are invalid.